Antenna

The old antenna I hung under the upstairs porch was not cutting it !

cr_09

So I made my own out of welders rods & Stainless Steel mesh !

Cr_09

Author of “TV Antenna Plans” is unknown

TV Antennas do not need to be complicated or expensive. There are some simple yet effective homemade TV Antenna designs that can be built at home with parts you may already have around your house.

Build a HDTV Antenna
One of the most effective “Build Your Own HDTV Antenna” plans is based on a design called the DB4. The DB4 is regarded as one of the better “general use” designs for pulling in HDTV signals in many situations. Most flat screen TV’s have a digital tuner for HDTV built in, but if you have an older set you may need a digital converter box to convert a signal from an antenna like this into something the older analog sets can display.

DB4 antennas are available commercially starting around $40 and up, but here I will show you how to build your own for much less than that.

On the right screen, digital TV can be a much different experience than what TV used to be, so set-up your home theater with the best flat screen tv to get the best value from an antenna like this.

Build your own HDTV Antenna Plans
Here’s what you need to get started:
22 inch section of 2×3 or 1×3 board
18 Screws
18 Washers, sized to fit on the screws to clamp down wire
15 feet of wire. Roughly 5 feet of copper three conductor house wiring will do fine. Coat-hangers can work if stripped of paint at all connections.
Reflector grid (Mesh like reflective metallic material.) Two 15×9 grill screens work well for a few dollars. (See first video below.)
One Balun – A thing with a coax plug on one side, two wires with screw holes on the other. These are commonly used to attach old TV’s to coax antenna’s (or cable.) They are inexpensive (I’ve seen them in bulk for as little as 30 cents each), and commonly available. My local dollar store carries them!
Tools:
Drill
Screw driver, or screw bit for drill
Wire cutters
Pliers

Step 1 – Find, Measure and Mark a piece of wood
Find a board similar to a 2×3 or 1×3
Mark lines at the marks pictured below

ant
Step 2 – Make 8 wire V’s out of wire
Cut eight 14″ long sections of wire.
Find the center, and bend each wire into two 7″ long legs, with a 3″ gap. (7″ legs with a 3″ gap is important!)

ant2
Step 3 – Attach wires to board
Attach the “V” wires the to board using screws and washers, as shown in the image.
Zig-Zag the two connection wires down and across the center of the board as shown. It is important that when the wires cross each other, they do not touch.

ant3
Step 4 – Attach Reflector
Attach the Reflectors to the back using screws. The Reflectors must not touch the “V” wires.

ant4
Step 5 – Attach the Balun
Attach the Balun to the two center sections of wire. Make sure the two connections do not touch each other.

ant5
Step 6 – You’re Done! Test your antenna!
Attach your antenna to your HDTV using a coax cable, and see how it works!

√ 🚫No Solicitors

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s